Removing
1. Remove the lower overlay under the instrument panel on the driver's side.
2. Disconnect the plug 1 and carefully remove the brake light switch 2 (see illustration).
11.2 Disconnect plug 1 and carefully remove brake light switch 2
Installation
3. Depress the brake pedal.
4. Install the brake light switch 2 into the mounting hole on the bracket (see illustration).
11.4 Install brake light switch 2 into the mounting hole on the bracket
5. Squeeze out a brake pedal a hand, and then slowly release. The switch should return to its original position when the pedal is released.
6. Connect the plug (see illustration 11.4).
7. Turn on the ignition, check the operation of the brake lights. The stop lamp should light up immediately only when the brake pedal is touched, and not at the moment the brake actuator is activated.