Location of the brake light switch on the brake pedal suspension
Switch (indicated by an arrow) installed on the brake pedal suspension.
Removing
1. Remove ground wire from battery.
2. Disconnect the electrical connector, unscrew the switch and remove it from the bracket.
Installation
1. Press the brake pedal to the stop.
2. Install the switch in the brake pedal mount.
3. Release the brake pedal until it contacts the switch.
4. Connect the electrical connector and ground wire to the battery.
5. Check the operation of the brake lights. The brake lights should come on after the brake pedal is depressed approximately 5 mm.
Adjustment
The stoplight switch is self-adjusting.