Arrangement of nuts of fastening of the lever of a manual brake
1 - lever, 2 - holder, 3 - cable tip
Removal and installation
1. Disconnect the rear of the front handbrake cable from the right rear cable under the vehicle.
2. On conventional center console models, tighten the handbrake lever, and remove the handbrake trim from the top of the center console.
3. Remove the trim on the handbrake lever.
4. On models with enhanced center console, remove the center console.
5. Under the vehicle, to access the handbrake lever mounting nuts, remove the intermediate link of the exhaust system and the heat shield.
6. Unscrew the four nuts securing the handbrake lever.
7. Lower the handbrake lever under the vehicle and disconnect the wire from the handbrake indicator light switch.
8. Disconnect the handbrake cable from the lever.
9. Installation is carried out in the reverse order of removal.
10. Check and, if necessary, adjust the operation of the hand brake.