Examination
Cm. subsection 12.7.
Removal
1. Remove the brake pads.
2. Using chalk or paint, mark the position of the brake disc relative to the hub.
3. Unscrew the screws securing the brake disc to the hub and remove the disc.
Installation
1. Installation is carried out in the reverse order of removal, taking into account the following points.
2. Check that the working surfaces of the brake disc and hub are clean and not deformed.
3. Align the previously made marks, install the brake disc and secure with screws, tightening them to the required torque.
4. If a new brake disc is being installed, use a solvent to clean it of the protective grease.
5. Install the brake pads.
6. Install the wheel and lower the vehicle.