2. Loosen the sensor mounting bolt.
3. Disconnect the electrical connector at the front of the suspension strut.
4. Disconnect the electrical connector located at the rear of the side wall of the luggage compartment on the corresponding side.
5. Check the condition of the gear wheel and the working surface of the sensor.
Attention! New sensors are supplied with a self-adhesive plate on the work surface. This plate must be removed before installation.
6. Install the sensor in the socket and secure with a bolt (This bolt must be lubricated with Loctite Frenetanch before installation).
7. Check the air gap between the sensor and the gear, which should be 0.5 mm.
8. Check sensor signal.
9. On models with a Bendix system with ABS, perform the following steps.
10. Loosen the sensor adjuster bolt.
11. Place a 0.5 mm feeler gauge between the tip of the sensor and the sensor ring on the drive shaft.
12. Press the sensor towards the probe, tighten the regulator bolt to the required torque.
13. Remove dipstick.