Removal
1. Remove the negative terminal from the battery.
Front door
2. If the door contains any electrical components, remove the door trim and protective film.
3. Disconnect the connectors from the electrical components and mounting brackets. Remove the rubber sealing ring from the front edge of the door. Remove the electrical wiring from the door.
4. Use a pencil or marker to mark the position of each door hinge relative to the door to facilitate subsequent installation and adjustment.
 |
 |
5. Unscrew the bolts securing the door stop to the pillar (photo on the left) and remove the rubber cover (photo on the right).
6. While supporting the door, unscrew the hinge mounting bolts and remove the door.
7. If it is necessary to replace the door opening hinges, mark their position on the door with a marker, unscrew the bolts and remove the hinges.
8. Install the new hinges according to the marks made earlier and screw them in place with bolts.
Back door
9. Open the front door to access the rear door wiring connector. Turn the connector lock ring counterclockwise and remove the connector from the door.
10. Use a pencil to mark the position of each hinge relative to the door. Unscrew the bolts (indicated by arrows) door stop to the pillar and remove the rubber protective cover. Supporting the door, unscrew the hinge mounting bolts and remove the door.
Installation
Front door
1. Install the door in place and secure the hinges with bolts. Align the hinges with the marks made earlier and tighten the bolts to the required torque.
2. Install the rubber protective cover onto the door stop and screw the stop to the pillar.
3. Connect the electrical connectors. Install the protective film and trim on the door.
4. Check the door installation and adjust if necessary.
Back door
5. Install the door and secure the hinges with bolts. Align the hinges with the marks made earlier and tighten the bolts to the required torque. Install the rubber boot on the door stop and screw the stop to the post. Connect the electrical connector to the door and secure it with the locking ring.
Adjustment
Close the door and check its alignment with the body panels. If minor adjustments are necessary, loosen the hinge mounting bolts. Move the hinges on the pillar to adjust the door position and tighten the hinge mounting bolts.
[Original text is located at: www.PeugeotBook.ru]