Removing
Remove the rear axle.
Remove the bolt (1) and remove the cover (2).
Special fixtures:
1 - insert for installation of an elastic hinge 0549-C1;
2 - counterholder for removal-installation 0549-D1 / 0549-E3;
3 - insert for removing the elastic hinge 0549-VZ;
4 - bracket 0549-A;
5 - washer 0549-F3.
Mark the location of the silent block (3) rear axle in relation to the suspension arm.
Narrow ledge oriented upwards (in the zone «A»).
Wide ledge oriented downwards (in the zone «b»).
Install tools [2], [5] on the bushing of the silent block (3) rear bridge.
Install tools [3], [4] on the silent block (3) rear bridge.
Attention. Make sure that the tool bolt [4] is on the axis of the rear axle silent block.
Remove the silent block (3) rear axle by screwing in the tool screw [4].
Remove tools [2], [3], [4], [5].
Installation
Attention. Observe the correct positioning of the silent block (3) rear bridge.
Check the positioning of the silent block (3) rear axle in relation to the suspension arm.
Narrow ledge oriented upwards (in the zone «A»).
Wide ledge oriented downwards (in the zone «b»).
rubber lug (in the zone «With») centered on the notch (in the zone «d»), the discrepancy should not exceed 5°.
Install tools [2], [5] on the bushing of the silent block (3) rear axle (proceed in the reverse order of removal).
Position the silent block (3) rear bridge.
Install articulated arm (3) and fixtures [1], [4].
Attention. Make sure that the tool bolt [4] is on the axis of the rear axle silent block.
Screw in the bolt of the tool [4] until the silent block is in place (3) rear bridge.
Remove tools [1], [2], [4], [5].
Replace the cover (2) and hand-tighten the bolt (1) (without delay).
Install the rear axle.