Table of contents: Removal 🠇 Installation 🠇
Special devices:
1 - extractor "Facom" L53 (K2+T2) 4108-T;
2 - screw 9501-T.A;
3 - bearing extractor support plate 0621.B;
4 - nut 9501-T.C1;
5 - puller 9501-T.D4 + 9501-T.D5;
6 - auxiliary insert 9501-T.C2;
7 - bearing installation tip 0621.1;
8 - insert for installation 0621.P.
Removal
Remove the front steering knuckle (see the corresponding operation).
Remove the front hub bearing snap ring (1).
Clamp the front hub in a vice.
Install fixture 6.
Install devices 5 and 2.
Press out the hub with the inner bearing half ring (2).
Install two wheel bolts into the hub, then place it in a vice.
 |
 |
(Original is contained on the portal: «www.PEUGEOTBOOK.ru»)
Press out the inner ring (2) using an extractor.
Install the new inner ring (2) into its seat.
Install tool 4 on the bearing separator.
Install fixture 3.
Remove the bearing using a press.
Installation
Install fixture 7.
Install the bearing until it stops using a press.
Install a new bearing retaining ring (1) into the socket.
Caution: The retaining ring must not cover the space "b" to allow installation of the ABS sensor.
Check the position of the retaining rings (1).
Install accessories 4 and 8.
Install the hub by pressing until it stops.
Install the steering knuckle onto the vehicle (see the corresponding operation).