Special fixtures:
1 - thrust cap 0621-N;
2 - mandrel for mounting 0621-M;
3 - mandrel for mounting 0621/3-D;
4 - mandrel for mounting 0621/3-C.
Remove the front lower suspension arm (see corresponding operation).
Withdrawal (rear silent block)
Mark the angular position of the rear silent block on the lower suspension arm (in the zone «A»).
Install tools [1], [2] on the rear silent block (1).
Remove the silent block (1) using the press.
Withdrawal (front silent block)
Install tools [1], [2] on the front silent block (2).
Remove the silent block (2) using the press.
Attention. Silent blocks are installed with an interference fit in the suspension arm. Installation of silent blocks must be carried out with a pressing force.
If one of the silent blocks is installed with a gap (free), replace the suspension arm.
Installation (rear silent block)
Attention. Observe the positioning of the silent blocks in relation to the suspension arm.
Install silent block (1).
Install tools [1], [3], [2] on the rear silent block.
Insert silent block (1) in the press until the tool [3] stops against the lower front suspension arm.
Remove tools [2], [3], [1].
Installation (front silent block)
Install silent block (2).
Install tools [1], [4], [2] on the front silent block.
Insert silent block (2) in the press until the tool [4] stops against the lower front suspension arm.
Remove tools [2], [4], [1].
Install the lower front suspension arm.