Table of contents: Removal 🠇 Installation 🠇
Removal
Secure and raise the vehicle on a two-post lifting platform.
Remove the wheel.
Unscrew the three bolts (1) and remove the protective shield (2).
Unscrew the bolt (3) and remove the ABS sensor (4).
Remove the brake caliper (see the corresponding operation).
Remove the brake disc (see the corresponding operation).
Remove the plug (5) and unscrew the hub nut (6).
Install tools 3 and 4 on the rear hub (7).
Provide support on the inner bearing race to remove the bearing assembly.
Remove the rear hub with bearing (7).
Installation
Note: The hub and bearing are non-separable, so the entire assembly must be replaced after each removal.
Clean and lubricate the journal (G6 grease).
Install the new hub with bearing (7) on tool 1.
Screw sleeve 1 onto the journal.
Screw support sleeve 2 onto sleeve 1.
Tighten the support sleeve 2 until the hub with bearing (7) reaches its extreme position.
Remove tools 1 and 2.
Note: Replace the hub nut (6) each time it is removed.
Tighten the nut (6) and lock it.
Install the remaining parts in reverse order.
Lubricate the bolt (3) with the compound "Loctite Frenetanch" and tighten.
Bleed the brake system (see the corresponding operation).
Install the wheel.