Removal and installation of a power shaft
1. Raise the corresponding side of the vehicle and drain the oil from the axle.
2. Remove the wheel, remove the cotter pin and the protective cover of the drive shaft nut.
3. Using the lever, fix the hub and loosen the drive shaft nut.
4. Loosen the drive shaft nut.
5. Loosen the bearing housing bolts (indicated by arrows) from the inside of the lever.
6. Remove the hub from the drive shaft.
7. Installation consists of following the steps in reverse order to the removal process, first replacing the drive shaft seal in the drive axle housing. The last operation is to fill the bridge with oil.