- air temperature outside;
- autonomy;
- current fuel consumption;
- average fuel consumption;
- average speed;
- distance traveled.
Multifunction display
The right side of the multifunction display shows information related to the use of the on-board computer.
Using the on-board computer
A short press on the button located at the end of the wiper lever is sufficient. Each subsequent press will cause the next type of information to appear on the display.
To reset the computer, keep the button pressed for more than three seconds.
If the battery has been disconnected, do the following:
- turn on the ignition. At the same time, 6 digital segments on the display and all symbols will light up.
- press the button once. If the computer is running, the outdoor temperature will appear on the display.
Outside temperature
The outside temperature appears on the display when the ignition is switched on. The flashing of the°С symbol means that the windows are likely to be iced.
Autonomy
Allows you to judge the number of kilometers that can still be driven with the fuel remaining in the tank (calculated based on the actual fuel consumption during the last 10 minutes). When there is less than 4 liters of fuel left in the tank, only three digital segments light up.
Attention! When the fuel level gauge shows the minimum level, the on-board computer automatically switches to the autonomy indication mode, regardless of what information was displayed before.
Current fuel consumption
This is the value that is determined during the last 2 seconds. This function does not work at speeds below 20 km/h. The limit figure that the display can show is 30 l / 100 km.
Average fuel consumption
It is defined as the ratio of the amount of fuel used to the distance traveled since the last reset of the on-board computer. The limit figure that the display can show is 30 l / 100 km.
Average speed
It is determined starting from the last reset of the computer and is calculated by dividing the distance traveled by the time of the trip, starting from the moment the ignition was turned on.
Distance traveled
This is the distance traveled since the computer was last reset.
After resetting the on-board computer, information about the autonomy will not be displayed until the car has traveled a certain distance.
If the display shows horizontal bars instead of numbers when driving, consult a Peugeot station.