Automatic air conditioning
In mode "AUTO" The system provides automatic maintenance of the set air temperature in the vehicle interior. At the same time, the electronic control unit regulates the temperature and flow of air entering the passenger compartment through the ventilation grilles, and also, if necessary, turns on the air conditioner.
The choice of air distribution mode in the cabin is carried out manually.
If necessary, the air recirculation mode is automatically switched on. When the air conditioner is in automatic control mode, the central display 3 is off.
For a few seconds after the ignition is turned on, a slight noise from the operation of the air conditioner units may be heard. This is normal.
Air conditioning control in automatic mode
1. Switching between air recirculation and supply ventilation modes.
2. Turn on and off the air conditioner.
3. Display.
4. The switch of the program of maintenance of transparency of glasses. The program provides for an increase in the air supply to the windshield and front door windows, for example, in case of high humidity. There is no need to change the set air temperature. If the air conditioner was operating in manual control mode, pressing the button turns the air conditioner into automatic mode. A constant flow of air passes through the central and side ventilation grilles, which depends on the set operating mode of the air conditioner.
5. Button for switching on the mixed air distribution mode: part of the air is directed to blowing the windshield (defrosting and condensate removal), and the other part enters the cabin through the central and side ventilation grilles, as well as through the air duct openings to the footwell areas of the front and rear passengers.
6. Button for switching on the air distribution mode: air flow through the central and side ventilation grilles.
7. Button for turning on the air distribution mode: most of the air enters the passenger compartment through the central and side grilles, and a smaller part - through the air duct openings in the footwells of the front and rear passengers.
8. Button for turning on the air distribution mode: most of the air enters the passenger compartment through the air duct openings in the footwells of the front and rear passengers, and a smaller part - through the central and side grilles.
9. Buttons for setting the value of the air temperature in the cabin. Possible temperature range: from 14°С to 30°С. The set temperature is shown on the display. It is recommended to first set the temperature at around 22°C and then gradually change the setting to the desired value.
10. Button "AUTO". It includes a program to maintain the most comfortable conditions in the cabin, while removing condensate from the windows. The indicator lights up on the display "AUTO".
11. Air flow regulation.
A. Diagram of fan operation mode.
Attention! The air conditioning control system includes an air temperature sensor built into the overhead console and a solar radiation sensor located between the windshield blower nozzles at the front of the control panel.
Manual air conditioning control
Air supply is controlled by button 11 "MAN". The air supply is increased or decreased by pressing the right or left edge of the button respectively. The set fan operation mode is reflected graphically on the display (diagram A). At the minimum air supply level, one vertical bar lights up. Turning off the fan will turn off the air conditioner. At the same time, the fan symbol goes out and the symbol lights up on the display "ECO".
The operating mode of the ventilation system is set by button 1 "RECIRC".
Air recirculation. The symbol lights up on the display. Turns on with a single press of the button. The access of outside air to the cabin is stopped and thus the ingress of unpleasant odors and dust is excluded. The air conditioning system circulates the air inside the car. The recirculation mode should only be used in exceptional cases.
Forced ventilation mode. The symbol lights up on the display. Turns on when button 1 is pressed again "RECIRC". In this mode, fresh outside air enters the passenger compartment.
The air conditioner is turned on with button 2 "A/C". When button 2 is pressed once, the air conditioner switches to automatic control mode (previously the air conditioner worked in the same mode), the symbol lights up on the display "A/C". Pressing button 2 again turns off the air conditioner. At the same time, the symbol lights up on the display "ECO". To return to automatic mode, press button 10 "AUTO". At the same time, the symbols for manual control of the air conditioner that were lit on the display will go out.
Tips for Using the Air Conditioner
To achieve a comfortable interior temperature more quickly, first set the temperature to 22°C and then gradually change the setting to the desired value.
Use the manual control of the air conditioner only if the uncomfortable temperature in the passenger compartment remains for a long time.
If the car is not in use, the manual mode settings are stored in the memory of the air conditioning control unit. However, if the temperature in the passenger compartment changes significantly from the set value, the air conditioning control program is automatically activated, which ensures that comfort conditions are reached as soon as possible. In any case, press the button "AUTO" to return to automatic mode.