Signaling device of inclusion of a parking brake and falling of level of a brake liquid
The indicator lights up when the parking brake is on or not completely off and when the brake fluid level in the reservoir drops below the permissible limit (the indicator remains on even after the parking brake is completely released). When turning on the signaling device, stop immediately and eliminate the cause of its ignition.
Central malfunction indicator
It is connected to the engine oil pressure drop indicator. When turning on the alarm, stop immediately.
Battery discharge indicator
The signaling device lights up when:
- failure of the electric circuit of the battery charge;
- loosening of the fastening of the battery or starter terminals;
- breakage or loosening of the alternator drive belt;
- generator failure.
ABS malfunction indicator
The signaling device burns at violation of operability of ABS. In this case, the braking system operates normally.
Engine oil pressure drop indicator
It is connected to the central fault indicator. When turning on the alarm, stop immediately. The indicator lights up when there is insufficient oil pressure or its absence in the engine lubrication system. If necessary, add oil to the required level.
Coolant level warning device
When turning on the alarm, stop immediately. Allow the engine to cool before adding coolant. Be aware that there is excess pressure in the cooling system. Before removing the cap of the expansion tank, turn it first to the first mark in order to reduce the pressure in the system.
Diesel engine glow plug indicator
Start the engine only after the indicator goes off.
Diesel fuel filter water ingress indicator (depending on the country of delivery)
Immediately remove the water from the filter, for which contact the service station. Possible failure of the high pressure fuel pump.
Signaling device for automatic on-board engine diagnostics
The signaling device lights up at violation of operability of system of injection of fuel or system of ignition. If the vehicle is equipped with a catalytic converter, it may be damaged.
Coolant temperature gauge
The position of the arrow in the middle of the scale corresponds to the normal temperature of the engine. An increase in coolant temperature can be caused by the following reasons:
- electric fan failure. Check fuses and replace faulty ones;
- coolant leak. Check fluid level with engine cold. Before removing the cap of the expansion tank, first turn it to the first mark in order to reduce the pressure in the cooling system;
- water pump failure;
- loose or broken drive belt.
Minimum fuel level indicator in the tank
The signaling device turns on if the remaining fuel in the tank does not exceed 7 liters. The tank capacity is about 70 liters.
Front brake pad wear indicator
If the warning light comes on, replace the brake pads as soon as possible.
Door open signaling device
It will stay on until all doors are tightly closed.
Front airbags
Side airbags
The signaling devices burn for 6 seconds after the ignition is turned on, then go out. The airbag may be malfunctioning if:
- the indicator does not light up when the ignition is turned on;
- the signaling device does not go out after 6 seconds;
- the alarm flashes for 5 minutes and then stays on.
Horn, headlight signaling, direction indicators
If, when the outdoor lighting is off, you press the lever (indicated by an arrow) toward you, the position lights will come on or the low beam headlights will turn on. In the latter case, the efforts of the limiter should not be overcome. The headlight alarm is activated even when the ignition is off.