Gearbox — installation (Peugeot 605)

25. Install a new sealing ring 33 of the torque converter (see illustration).



26. Install the torque converter so that the fastening A is facing downwards (see illustration).



27. Align the engine and gearbox (see illustration).

Source of the article is posted at: PeugeotBook



28. Install the speedometer sensor.



29. Screw in the gearbox mounting bolts to the engine and tighten them to 65 Nm

30. Install the gearbox mounting bracket, tighten nut 26 of support 28 with a force of 65 Nm, and bracket bolts 27 with a force of 30 Nm (see illustration 7.20).

31. Remove the crossbar using a special crane or garage lift (depending on what was used during removal).

32. Jack up the car.

33. Screw in and tighten the torque converter mounting bolts 34 33 in several passes (see illustration), turning the crankshaft to gain access to the bolt holes:

• 1st pass - 20 Nm;
• 2nd pass - 60 Nm.

34. Next, the installation of the dismantled parts is carried out in the reverse order of removal.