Table of contents: Poor quality of glass cleaning.…🠇 The remaining water in the cleaning…🠇 The brush works one-sidedly. It…🠇 There are still some uncleaned areas…🠇
Poor quality of glass cleaning. Smudges, smudging
The rubber band is dirty
Clean the rubber band with a hard nylon brush and detergent or alcohol.
Fringe of the working surface of the rubber band. The tape is torn or worn out
Replace the rubber band.
Aging of rubber band. Cracked surface
Replace the rubber band.
The remaining water in the cleaning zone is collected into beads
The glass is oily or contaminated with polish
Clean the glass with a clean cloth and a silicone-based grease and oil stain remover.
The brush works one-sidedly. It cleans one half of the cleaning area well, but the other half poorly. The brush vibrates during operation
Deformation of the rubber band. The working surface of the tape does not rotate to the other edge
[Material copied from the resource: PeugeotBook.ru]
Install a new rubber band.
The brush lever is displaced. The brush does not adhere to the glass
Carefully adjust the position of the brush lever.
There are still some uncleaned areas left
The rubber band has come out of its mount
Carefully feed the tape into the holder.
The rubber band does not adhere evenly to the glass because the holders are bent
Replace the rubber band. This malfunction usually occurs due to improper installation of the spare brush.
Weak lever pressing force
Lubricate the lever pivots and springs or install a new lever.