Ignition system amplifier module (composite ignition) (Peugeot 405)

The ignition system amplifier module is located on the right rear side of the engine compartment.

1. Remove the ground wire from the battery.

2. Remove the electrical wiring connector, unscrew the two mounting screws and remove the amplifier module.

(Source of the article is website: «www.PEUGEOTBOOK.ru»)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed by editor: Shirokov Arseny

Share information:

Peugeot 405: Ignition system

Ignition coil (composite ignition)
Composite ignition system (ignition/fuel system)
Checking the vacuum regulator in a car
Checking the centrifugal regulator in a car
Setting the ignition timing

Removal the ignition distributor (composite ignition)
Installing the ignition distributor (composite ignition)
Direct ignition system
Ignition coil (direct ignition)
Ignition system booster modules (direct ignition)

See similar information for other Peugeot models

➨ Ignition system amplifier unit — removal and refitting Peugeot 106 (1991-2003)
➨ General information about the ignition system of the TU5 petrol… Peugeot 207 (2006-2014)
➨ Ignition system Peugeot 306 (1993-2002)
➨ Ignition System — General Information and Precautions Peugeot 605 (1989-2000)
➨ Fuel injection and ignition system. 2.0-liter turbocharged engine Peugeot 806 (1994-2002)

Link to this article in different formats

TEXTHTMLBB Code

Comments and feedback from visitors