Ignition coil (composite ignition) (Peugeot 405)

The ignition coil is installed on the left end of the cylinder head.

1. Remove the ground wire from the battery.

2. Remove the connector from the ignition coil.

3. Mark the position of the high-voltage wires on the ignition coil and remove them from the coil terminals.

4. Unscrew the four mounting screws and remove the ignition coil.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed by editor: Shirokov Arseny

Share information:

Peugeot 405: Ignition system

Composite ignition system (ignition/fuel system)
Checking the vacuum regulator in a car
Checking the centrifugal regulator in a car
Setting the ignition timing
Disassembly and assembly of the Bosch distributor

Ignition system amplifier module (composite ignition)
Removal the ignition distributor (composite ignition)
Installing the ignition distributor (composite ignition)
Direct ignition system
Ignition coil (direct ignition)

See similar information for other Peugeot models

➨ Ignition HT coil — removal, testing and refitting Peugeot 106 (1991-2003)
➨ General information about the ignition system of the TU5 petrol… Peugeot 207 (2006-2014)
➨ Ignition system specification Peugeot 305 (1977-1989)
➨ Ignition System — General Information and Precautions Peugeot 605 (1989-2000)
➨ Ignition coil Peugeot 806 (1994-2002)

Link to this article in different formats

TEXTHTMLBB Code

Comments and feedback from visitors