Assembling the primary shaft (Peugeot 405)
If one of the bearings is removed due to damage, the corresponding bearing must be installed on the press.
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Article reviewed by editor: Shirokov Arseny
Share information:
See similar information for other Peugeot models
➨ Disassembling the primary shaft of the MA5 and BE4/5 manual… Peugeot 207 (2006-2014)
➨ Drive shaft — disassembly and assembly Peugeot 305 (1977-1989)
➨ Drive shaft CV joint covers — inspection Peugeot 605 (1989-2000)
➨ Checking the condition of the drive shaft covers Peugeot 806 (1994-2002)
Link to this article in different formats
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance (gasoline)
- Maintenance (diesel)
- Power unit
- Gasoline engines
- Diesel engines
- Engine overhaul
- Cooling and heating
- Fuel system (gasoline)
- Fuel system (diesel)
- Engine electrical equipment
- Transmission
- Clutch and drive shafts
- Mechanical gearbox
- Automatic gearbox
- Chassis, running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits
- General information
- User manual
- Maintenance
- Power unit
- Petrol engines 1.4 l
- Petrol engines 1.6-2.0 l
- Diesel engines
- Ignition system
- Fuel system (carburetor)
- Single point fuel injection
- Multipoint fuel injection
- Cooling and lubrication system
- Exhaust system
- Transmission
- Clutch
- Manual gearbox MA
- Manual gearbox BE
- Automatic gearbox
- Drive shafts
- Chassis, running gear
- Steering
- Front suspension
- Rear suspension
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits