Table of contents: Front seats 🠇 Back seat (models with folding rear…🠇
Front seats
 |
 |
1. Remove the screw securing the rear outer seat trim (photo on the left) and remove the trim upwards (photo on the right).
2. Remove the seat belt mounting bolt from the bottom of the front seat.
3. Move the front seat forward as far as it will go, unscrew the screws securing the rear runners to the car floor.
4. Move the front seat as far back as it will go. Unscrew the bolts securing the front of the runners to the floor.
5. Raise the seat and disconnect the electrical connector from the seat belt tensioner. Remove the motors if applicable.
Back seat (models with folding rear seat)
6. Remove the rubber plugs (indicated by the arrow) from the seat cushion mounting posts and unscrew the mounting nuts.
7. Slide the seat cushion forward and lift it up to release the rear seat retaining clips. Remove the rear seat cushion from the vehicle.
8. To remove the side cushions, unscrew the mounting bolt at the base of the cushion.
9. Remove the side airbag upwards from the vehicle.
 |
 |
10. To remove the rear seat back on split seat models, remove the rivets (indicated by arrows in the photo on the left) securing the front section of the luggage compartment carpet to the floor and fold the carpet back to access the bolts (indicated by arrows in the photo on the right) fastenings of the central part of the seat.
11. Unscrew the bolts securing the rear seat backs to the vehicle body and remove them.
12. Installation is carried out in the reverse order of removal.