2. Remove the wiper arm.
3. Loosen the lock nut.
4. Remove the left and right plastic covers of the ventilation system from the base of the windshield.
5. Remove the left and right vents at the bottom of the windshield to access the wiper motor.
6. Disconnect the electrical connector located on the wiper motor power wires.
7. Loosen nuts and bolts (indicated by arrows in the photo on the left) wiper mounts and remove the wiper (photo on the right).
8. Remove the rubber damping pads from the wiper.
9. If necessary, mark the relative position of the motor shaft and the crank, unscrew the nut (1) and remove the wiper link from the motor shaft. unscrew the bolts (2) engine mounts and remove the tie rods from it.
10. Installation is made in sequence, return to removal.