Oil level sensor — removal and installation (Peugeot 406)

Removal the oil level sensor

The sensor is located on the rear side of the cylinder block lining on the flywheel side.

The best access to the sensor is from underneath the vehicle.

Removal and installation

Cm. subsection 6.1.6.

(Original published on the portal: PeugeotBook.ru)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed by editor: Vinogradov Robert

Share information:

Peugeot 406: Engine electrical equipment

Oil pressure sensor — removal and installation
Starter — removal and installation
Engine Starting System — Check
Alternator — Removal and Installation
Charging system — description and testing

Ignition system (petrol engines) — description
Checking the ignition system
Ignition coil — removal and installation
Setting the ignition timing
Pre-heating system (diesel engines)

See similar information for other Peugeot models

➨ Oil level sensor — removal and refitting Peugeot 106 (1991-2003)
➨ Replacing the engine oil level and temperature sensor (TU5… Peugeot 207 (2006-2014)
➨ Low Coolant Level Sensor (General Information) Peugeot 305 (1977-1989)
➨ Scheme 12. Windscreen washer and wiper, heated jets and washing… Peugeot 605 (1989-2000)
➨ Fuel level indicator sensor — removal and installation Peugeot Partner I (1996-2008)

Link to this article in different formats

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet