- turn off the ignition and disconnect the wire «masses» from the storage battery;
- move the front seat forward as far as it will go;
Pic. 10.80. Bolt location (1) securing the rear parts of the front seat slide
- remove two screws 1 (pic. 10.80) fastening the rear parts of the seat slide;
- move the front seat back as far as it will go;
Pic. 10.81. Bolt location (1) attachment of the front parts of the front seat sled
- remove two screws 1 (pic. 10.81) fastening the front parts of the seat slide;
- disconnect the electrical connectors from the seat;
- remove the front seat from the vehicle.
To install the front seat:
- make sure that the seat rails are parallel to each other;
- raise the seat height adjuster to its highest position before reinstalling it;
- move the front seat back as far as it will go;
Pic. 10.82. The sequence of tightening the bolts of the front seat sled: A - left seat; B - right seat
- screw in the bolts for fastening the front parts of the seat slide and tighten them with a torque of 20 Nm in the sequence shown in fig. 10.82;
- move the front seat forward as far as it will go;
- screw in bolts of fastening of back parts of a sled of a seat and tighten them the moment of 20 Н·м in the sequence shown in fig. 10.82;
- connect wire «masses» to the battery;
- initiate all electronic systems.