- remove the front seat;
- slide the small luggage pocket under the front seat;
- remove the pocket in the back of the front seat by pulling it down;
Figure 10.83. Location of seat adjustment fasteners: 1 - backrest tilt adjustment lever; 2 - lever mounting cover; 3 - seat height adjustment lever; 4 - lever mounting screws
- release lever 1 from the clamps (figure 10.83) seat back tilt adjustment;
- remove cover 2, unscrew screws 4 and remove lever 3 for adjusting the seat height;
Figure 10.84. Location of the front seat reinforcement (1)
- remove the amplifier 1 from the seat (figure 10.84);
Figure 10.85. Seat fastening: 1 - seat trim; 2 - electrical connector; 3 - bolt
- unscrew bolt 3 (figure 10.85), move the trim 1 away from the seat adjustment drive side and disconnect the electrical connector 2;
Figure 10.86. Cable fastening: 1 - lever of the seat back forward folding drive mechanism; 2 - cable; 3 - cable sheath
- disconnect cable 2 (figure 10.86) from lever 1 of the seat back forward folding drive mechanism and cable sheath 3;
Figure 10.87. Location of rivets (1) for fastening the block (2) on the front seat
Original published on the portal PeugeotBook
- use a 7.5mm drill to drill out the rivets 1 (figure 10.87) and remove block 2;
Figure 10.88. Location of the axis (1) of the handle (2) of the drive of the forward folding mechanism of the seat back
- slide the seat cover to gain access to axle 1 (figure 10.88) swivel bracket;
- remove the swing arm axle;
- remove handle 2 of the seat back forward folding mechanism drive;
- remove the cable mounting shaft from the seat back forward folding mechanism drive handle;
- release the cable sheath fastening and remove the seatback forward folding mechanism drive cable from the front seat;
Installation is carried out in the reverse order of removal, taking into account that during installation there should not be a pocket for small luggage under the seat.
Figure 10.89. Location of the adjustment unit (1) of the drive cable of the forward folding mechanism of the seat back
The seat back forward folding cable is adjusted using adjustment block 1 (figure 10.89), which is installed under the seat cushion.
To adjust the seatback forward recline cable:
Figure 10.90. Lifting the locking button (A) with a flat-head screwdriver to release the cable in the adjustment block
- using a flat-head screwdriver, lift up the lock button A (figure 10.90), to unlock the cable in the adjustment block;
- make sure the cable moves freely in the adjustment block;
Figure 10.91. Retracting the seat back forward folding mechanism drive handle: X = 10 mm
- move the seat back forward folding mechanism handle 10 mm (figure 10.91);
- simultaneously lower the locking button A (see Figure 10.90) adjustment block under the seat;
- check the adjustment by moving the seat several times.