Table of contents: Removal 🠇 Installation 🠇
Removal
1. Remove the auxiliary drive belt.
2. To prevent the engine crankshaft from turning, have an assistant engage fourth gear and press the foot brake all the way. At this time, loosen the crankshaft pulley mounting bolt. If the engine is removed from the vehicle, secure the flywheel ring gear with a locking pin. Never secure the crankshaft using the hole in the timing pulley.
 |
 |
3. Remove the bolt and pull the pulley off the crankshaft. If the pulley is a sliding fit on the crankshaft using a key or pin, remove it. If the pulley is pressed onto the crankshaft, remove it using a puller.
Installation
1. Install the Woodruff key into the groove on the crankshaft. Install the pulley onto the crankshaft, aligning the groove on the pulley with the Woodruff key.
2. Clean the threads of the pulley mounting bolt and lubricate them with an anti-loosening agent (Peugeot recommends the use of Loctite Frenetanche).
3. Tighten the bolt with the washer securing the pulley.
4. Install and adjust the tension of the auxiliary drive belt.
Original publication on the website www.peugeotbook.ru