English Русский
Български
Беларускі
Український
Српски
Hrvatski
Română
Polski
Slovenský
Magyar
Bookmark Articles Sitemap Contacts
Company Hyundai Company Opel Company Skoda Company Kia Company Mitsubishi Company LADA Company Audi
PeugeotBook.ru
 
 
 
 
 
 
 
Series 100   Series 200   Series 300   400-500   Series 600   Crossovers   Others
 
Peugeot 405 (1987-1997) Peugeot 406 (1995-2004)

Rear door (Combi models) — removal and installation (Peugeot 405)

  • Main
  • 40X
  • Peugeot 405 (1987-1997)
  • Body and interior
  • Doors, locks and windows
  • Rear door (Combi models) — removal and installation
0
Table of contents: Back door 🠇 Rear door support pillars 🠇

Back door



Removal



1. Open the back door.

2. Unscrew the mounting screws and remove the plastic trim from the inside of the rear door.

3. Working around the edge of the carpet trim, release the fastening clips and remove the carpet trim.

4. Disconnect the electrical connectors from the trunk light switch.

Original can be viewed at [www.peugeotbook.ru]

5. Disconnect the connectors of the rear door wiper motor and the central locking motor through the holes in the rear door.

6. Remove the washer hose from the nozzle.

7. Release the wiring harnesses and washer hose from the mounting brackets inside the rear door.

8. Remove the sealing rings from the upper corners of the rear door.

9. If the rear door is to be reinstalled, tie a strong cord to the wires and hoses before removing them from the door and leave the cord in the door after removing the wires.

10. Support the rear door, then use a lever to remove the door support posts in the open position from the ball joints on the rear door.

10. Support the rear door, then use a lever to remove the door support posts in the open position…


11. Unscrew the nuts (indicated by arrows), securing the hinges to the top of the rear door, and remove the rear door from the vehicle.



Installation



1. Installation is carried out in the reverse order of removal, taking into account the following points.

2. If the rear door is being reinstalled, after installing the door, tie a strong cord that remains in the door after removing the wires to the wires and hoses, then tighten the wires and hoses into the door.

3. If necessary, adjust the rubber cushions to ensure the door closes properly.

4. Before installing the rear door trim, check and, if necessary, adjust the position of the rear door lock.

Rear door support pillars



Removal



1. Support the rear door in the open position.

1. Support the rear door in the open position.


2. Using a lever, remove the door support pillars in the open position from the ball joints on the rear door.

3. Similarly, remove the door support pillars in the open position from the ball joints on the body.

Installation



Installation is carried out in the reverse order of removal.
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Article reviewed by editor: Shirokov Arseny
Share information:
Previous
Peugeot 405: Doors, locks and windows
Next

Trunk lid lock (Sedan models) — removal and installation
Trunk lid (Sedan models) — removal and installation
Door glass — removal and installation
Door lock and handles — removal and installation
Door trim — removal and installation
Rear door lock (Combi models) — removal and installation
Electric windows
Windshield and rear glass
Sunroof — Removal and Installation
See similar information for other Peugeot models

➨ Rear brake shoe condition check — models with rear drum brakes Peugeot 106 (1991-2003)
➨ Disassembly and assembly of the rear bumper (3- and 5-door… Peugeot 207 (2006-2014)
➨ Removal and installation the rear window washer nozzle (Estate… Peugeot 305 (1977-1989)
➨ Rear Crankshaft Oil Seal (Flywheel Side) — Replacement Peugeot 605 (1989-2000)
➨ Rear folding door Peugeot 806 (1994-2002)
Link to this article in different formats
Comments and feedback from visitors
No comments yet


Add two numbers 45 + 44

       



Peugeot 406 (1995-2004) 
  • General information
  • User manual
  • Maintenance (gasoline)
  • Maintenance (diesel)
  • Power unit
  • Gasoline engines
  • Diesel engines
  • Engine overhaul
  • Cooling and heating
  • Fuel system (gasoline)
  • Fuel system (diesel)
  • Engine electrical equipment
  • Transmission
  • Clutch and drive shafts
  • Mechanical gearbox
  • Automatic gearbox
  • Chassis, running gear
  • Brake system
  • Car suspension
  • Steering
  • Body and interior
  • Exterior (external elements)
  • Interior (internal elements)
  • Doors, locks and windows
  • Electrical equipment
  • Equipment and devices
  • Electrical circuits
Peugeot 405 (1987-1997) 
  • General information
  • User manual
  • Maintenance
  • Power unit
  • Petrol engines 1.4 l
  • Petrol engines 1.6-2.0 l
  • Diesel engines
  • Ignition system
  • Fuel system (carburetor)
  • Single point fuel injection
  • Multipoint fuel injection
  • Cooling and lubrication system
  • Exhaust system
  • Transmission
  • Clutch
  • Manual gearbox MA
  • Manual gearbox BE
  • Automatic gearbox
  • Drive shafts
  • Chassis, running gear
  • Steering
  • Front suspension
  • Rear suspension
  • Brake system
  • Body and interior
  • Exterior (external elements)
  • Interior (internal elements)
  • Doors, locks and windows
  • Electrical equipment
  • Equipment and devices
  • Electrical circuits
PeugeotBook.ru © 2018–2026 | Mobile version | Sitemap: EN BG BY UA RS HR RO PL SK HU | Write message | Site search | Add to bookmarks | Peugeot owners
106 (1991-2003) | 206 (1998-2012) | 207 (2006-2014) | 305 (1977-1989) | 306 (1993-2002) | 307 (2001-2008) | 405 (1987-1997) | 406 (1995-2004) | 605 (1989-2000) | Partner-I (1996-2008) | Eurovans-807 (2002-2014) | Eurovans-806 (1994-2002) | J5 (1981-1993) |
Cookies are used to ensure the correct display of pages on the site.