Removing
1. Disconnect the wire terminals from the battery, remove the air filter, and then the battery.
2. Move aside the tank 1 of the refrigerant of the air conditioner without opening the circulation circuit (see illustration).
7.2 Move aside the tank 1 of the refrigerant of the air conditioner without opening the circulation circuit
3. Release from the holders, disconnect and move aside the wires attached to the battery tray 2 (see illustration 7.2).
Attention! To ensure proper wiring, after installing the tray, it is recommended to mark their position and attachment points (see illustration 7.3).
7.3 Cables and their holders on battery tray 2
A - support bracket
B - harness holder 4
C - harness holder 5
D - harness holder 6 and 7
E - harness holder 5 and 7
G - harness holder 9
H - harness holder 8
I - harness holder 9
J - harness holder 9
K - pipeline holder 10
F - installation place of the coolant tank
4. Unscrew the screw under the tray and remove the tray.
The tray is installed in the reverse order of its removal.