Removing
Disconnect the wire «masses» from the battery.
Drain the coolant.
Remove the toothed belt.
Pic. 3.94. Branch pipe location (2), water pump mounting bolts (1) and lids (3) water pump
Remove bolts 1 (pic. 3.94) fasteners and remove the water pump.
Attention! Do not loosen bolts 3 (see fig. 3.94) water pump cover fixings
Installation
Install new centering sleeves that determine the position of the water pump relative to the cylinder block.
Apply sealant to pipe 2 of the cooling system.
Install the water pump and secure with bolts, tightening them with a torque of 14 Nm.
Install the toothed belt.
Fill with coolant and bleed air from it.
Connect the wire to the negative terminal of the battery.