Table of contents: Removal 🠇 Installation 🠇
The brake light switch is located on the brake pedal bracket.
On models with automatic transmission, there are 2 switches located on the brake pedal bracket. Of these, the brake light switch is on the left.
Removal
1. Remove the fuse box cover.
2. Disconnect the connector from the key block.
3. Remove the screws and lower instrument panel trim. Access to the brake light switch (indicated by the arrow) is very difficult and can be improved by removing the steering column.
(Article based on material from the website PeugeotBook.ru)
4. Disconnect the electrical connector, unscrew the switch and remove it from the bracket.
Installation
1. Screw the brake light switch into the bracket so that the gap between the end of the switch housing and the protrusion on the brake pedal is 2-3 mm.
2. Connect the electrical connector to the switch and check the brake lights. The brake lights should come on after the brake pedal is depressed approximately 5 mm.