Removing
1. Raise the rear of the car and secure it on stands. Remove rear wheels.
2. Unscrew the nuts and remove the wings from the ends of the stabilizer.
3. Apply alignment marks between the installation bushings and stabilizer.
4. Unscrew the nuts (indicated by arrows) and remove the stabilizer mounting clips.
5. Remove the stabilizer from under the car and remove the installation bushings from it.
6. Check the stabilizer elements for wear and damage.
Installation
1. Install the rubber bushings on the stabilizer. Align the bushings on the stabilizer with the marks you made earlier and position them so that the flats are on top and the slot of the bushing faces towards the front.
2. Install the stabilizer and fix the clamps of its installation. Connect the wings to the ends of the stabilizer and tighten the nuts securing the stabilizer mounting clamps to the required torque.
3. Screw in new nuts securing the wings to the stabilizer and tighten them to the required torque.
4. Install wheels and lower vehicle.