The bodyshell is made of pressed-steel sections and is available in both three- and five-door Hatchback versions. Most components are welded together, but some use is made of structural adhesives; the front wings are bolted on.
The bonnet, door and some other vulnerable panels are made of zinc-coated metal and are further protected by being coated with an antichip primer, prior to being sprayed.
Extensive use is made of plastic materials, mainly in the interior, but also in exterior components. The front and rear bumpers are injection-moulded from a synthetic material which is very strong and yet light. Plastic components such as wheel arch liners are fitted to the underside of the vehicle, to improve the body's resistance to corrosion.
(Original text is located at: «PEUGEOTBOOK.ru»)
General information (Peugeot 106)
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Article reviewed by editor: Matveev Demid
Share information:
Link to this article in different formats
Comments and feedback from visitors
No comments yet
- General information
- Introduction to manual
- Weekly checks
- Maintenance (petrol)
- Maintenance (diesel)
- Troubleshooting
- Power unit
- Petrol engines
- Diesel engines
- Engine overhaul
- Cooling and heating
- Fuel system (carburetor)
- Single point injection (petrol)
- Multipoint injection (petrol)
- Fuel system (diesel)
- Emission control system
- Engine electrical equipment
- Ignition system
- Diesel heating
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Drive shafts
- Chassis, running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical diagrams