Table of contents: 954 and 1124 cc models 🠇 1294 cc modeis 🠇 1360 cc carburetor and singlepoint…🠇 1360 cc multi-point injection petrol…🠇
954 and 1124 cc models
1. Slacken the retaining clips (where fitted) and disconnect the vacuum and breather hoses from the front of the air cleaner housing-to-carburetor/throttle body duct. Where crimped-type hose clips or ties are fitted, cut and discard them; replace them with standard worm-drive hose clips or new cable ties on refitting.
2. Slacken the retaining clips, then lift the duct off the top of the carburetor/throttle body and air cleaner housing. Disconnect the air temperature control valve hose from the end of the duct, and remove the duct from the engine compartment. Recover the rubber sealing ring from the top of the carburetor /throttle body and/or air cleaner housing (as applicable).
3. Release the retaining clips securing the lid to the top of the air cleaner housing. Lift the lid away from the housing, and recover the sealing ring (see illustration). On some models, it will be necessary to twist the lid to release it.
22.3. Release the air cleaner lid retaining clips and lift off the lid
Inspect the sealing ring for signs of damage or deterioration, and renew if necessary.
4. Where the air filter element is not an integral part of the lid, lift the element out of the housing (see illustration). Fit the new element, making sure it is correctly positioned in the housing.
22.4. On some models, the air cleaner element is available separately from the air cleaner lid
5. Fit the sealing ring to the housing, then refit the lid and secure it in position with the retaining clips.
6. Refit the air cleaner-to-carburetor/throttle body duct. Ensure that the duct is correctly seated on its sealing rings, and securely tighten its retaining clips.
7. Reconnect the vacuum and breather hoses to the duct, and secure them in position with the retaining clips (where fitted).
1294 cc modeis
8. Slacken the retaining clip, and disconnect the intake duct from the side of the air cleaner housing.
9. Release the retaining clips, then remove the cover from the housing. Withdraw the filter element, noting which way around it is fitted.
10. Fit the new element, ensuring that it is fitted the correct way around and is correctly seated in the housing. Install the cover, and secure it in position with the retaining clips.
11. Reconnect the intake duct, and securely tighten its retaining clip.
1360 cc carburetor and singlepoint injection petrol models
12. Refer to the information given in paragraphs 1 to 7.
1360 cc multi-point injection petrol models, and all 1587 cc models
13. Slacken the retaining clip, and disconnect the intake duct from the air cleaner housing lid.
14. Release the retaining clips (where fitted), then unclip the lid and position it clear of the housing.
15. Recover the sealing ring from the top of the filter housing, and lift the element out of the housing. Inspect the sealing ring for signs of damage or deterioration, and renew if necessary.
16. Fit the new element, making sure it is correctly seated in the housing.
17. Refit the sealing ring to the top of the housing, and securely refit the housing lid. Where necessary, secure the lid in position with its retaining clips.
18. Reconnect the intake duct, and securely tighten its retaining clip.