Table of contents: Engine oil level indicator 🠇 Indication of the mileage until the…🠇 Resetting previous maintenance…🠇
4800 km left until the next maintenance
Indication of overdue maintenance
900 km left until the next maintenance
When the ignition is turned on, the following information appears on the instrument cluster display one after the other:
- mileage until next maintenance;
- engine oil level;
- total and daily mileage;
- position of the automatic transmission control lever.
Engine oil level indicator
1. The engine oil level reaches the maximum mark. If the indicator is flashing, the engine oil volume only needs to be topped up a little.
2. The engine oil level has reached the minimum mark. Check the level using the dipstick.
3. The engine oil level is low and oil should be added immediately to avoid engine damage.
4. Malfunction in the lubrication system (oil level sensor). Contact the workshop immediately.
Indication of the mileage until the next vehicle maintenance
Mileage countdown starts from the moment the previous data is reset (cleared) after performing maintenance (TO). The period until the next maintenance is calculated by the command-counting device based on mileage or time since the last maintenance.
After the ignition is switched on, the display shows a wrench symbol and the number of kilometres remaining until service for approximately five seconds, then changes to the daily/total mileage display.
If there are less than 1000 kilometers left until the next maintenance, then after this message is displayed for 5 seconds, it is replaced by the daily/total mileage readings, but the wrench symbol remains on the display.
If a maintenance deadline is missed, the display will show the number of kilometers traveled since the missed service for approximately five seconds after the ignition is turned on. This mileage is indicated by a minus sign. For example, if the mileage is 300 kilometers, the display will show a wrench and "-300 km.".
Resetting previous maintenance information and entering new information
After completing the next maintenance, the workshop deletes the old information and enters new data.
The car owner can perform this procedure independently using the daily mileage reset button, which is located on the indicator light panel.
1. Turn on the ignition.
2. Press button 1 and hold it down.
3. Turn off the ignition.
The next maintenance due date will start flashing on the display (mileage until next maintenance).
4. Keep button 1 pressed until "=0" disappears.
