Attention! The Peugeot 0615J special tool is required to install the front suspension lower ball joint. If this tool is not available, have the lower ball joint replaced at a service station.
Removing
1. Remove the steering knuckle and hub from the vehicle.
2. Remove the lower ball joint cover plate.
3. Using a hammer and flat punch, knock out the ball joint retainer.
4. Install the special tool on the ball joint, aligning the tool with the grooves (indicated by arrows) in the ball joint, and secure the tool by screwing the old nut onto the ball joint. Unscrew the ball joint from the steering knuckle.
Installation
1. Screw the ball joint into the steering knuckle.
2. Install the special tool, being careful not to damage the ball joint boot, and tighten the ball joint to the correct torque.
3. Using a hammer and punch, poke the ball joint into one of the grooves in the steering knuckle.
4. Install a new ball joint wear plate.
5. Install the steering knuckle together with the hub on the car.