Table of contents: Removal 🠇 Installation 🠇
Removal
1. Disconnect the negative battery terminal.
2. Remove the air filter.
3. Remove the accelerator cable from the throttle actuator.
4. Remove the electrical connectors from the throttle position sensor, heater elements, intake air temperature sensor, and idle air control motor.
5. Remove the vacuum hose and the crankcase ventilation hose.
6. Where necessary, loosen the bolts or screws and remove the accelerator cable hanger.
7. Remove the bolts and remove the throttle body from the intake manifold along with the O-ring gasket that needs to be replaced.
Installation
1. Installation is carried out in the reverse order of removal.
2. Please consider the following points:
Original is contained on the portal [PeugeotBook.ru]
- always use a new O-ring when installing the manifold, then carefully install the throttle body;
- check the correct installation of the previously removed hoses;
- check the correct installation of previously removed connectors;
- install the accelerator cable.