Automatic transmission with dipstick
16. Unscrew the drain plug 1 (see illustration) and drain the gear oil into a suitable container. It is impossible to completely drain the oil from the torque converter, so approximately 3 liters of oil is drained.
2.16 Unscrew the drain plug 1 and drain the gear oil
17. Screw in the drain plug and tighten it to 45 Nm.
18. To fill the gear oil, you can use a special tool (filling capacity), whose catalog number is 0340 (see illustration).
2.18 Tool 0340 for filling transmission oil
19. Connect the hose of filling container 0340 to the dipstick guide tube and gradually fill in 3 liters of fresh gear oil.
20. Start the engine and check the transmission oil level.
Automatic transmission without dipstick
21. Unscrew the drain plug 1 (see illustration 2.16) and drain the gear oil into a suitable container. It is impossible to completely drain the oil from the torque converter, so approximately 3 liters of oil is drained.
22. Screw in the drain plug and tighten it to 45 Nm.
23. Jack up the car, place it on jack stands.
24. Move the air filter away from the job site.
Attention! Do not disconnect the transmission oil temperature sensor.
25. Remove filler plug 2 with suitable pliers (see illustration).
2.25 Remove filler plug 2 with suitable pliers
26. Jack up the car.
27. Unscrew the plug 3 of the control hole (see illustration 2.11).
28. Connect gear oil filler 0340 to the filler hole and gradually add fresh oil until it starts to flow out of the control hole.
29. Start the engine, let it idle, depress the brake pedal, alternately move the gear lever to each of the seven positions and set the lever to position «R».
30. Top up the gear oil until it starts to flow out of the check hole.
31. Screw in the check hole plug.
32. Stop the engine. Check the transmission oil level.