Electric cooling fans — removal and installation (Peugeot Partner I)

Table of contents: Removal 🠇 Installation 🠇

Removal

1. Remove the radiator as described in paragraph 3.

2. Loosen the retaining ring and disconnect the round electrical connector at the lower left corner of the fan shroud. If using separate electrical connectors, trace the wiring from the fan and disconnect the corresponding electrical connectors.

3. On early models, lift up the ends of the fan shroud clips (one on each side) and slide the top of the casing towards the engine. On all models, lift the assembly to release the lower mounting tabs and remove it from the engine compartment.

4. To remove the fan motor from the casing, unscrew the three nuts and remove the bolts securing the corresponding motor to the casing. Remove the electric motor and fan assembly and disconnect the electrical connector. The fan can be removed from the motor shaft after removing the clamp or unscrewing the bolt (whichever is applicable).

5. To access the motor relay, release and remove the cover over the relay box located in the center of the fan shroud. Please note that on some models the relay box cover may be secured with a screw.

Data published on the website (PeugeotBook)

6. Remove the relay support plate from the housing, disconnect the electrical connector and remove the corresponding relay.