Puller for wiper arms 1335
Air intake grille
Switch off the ignition.
Remove (from each side) front wiper shaft cover. Loosen the nut (1).
Remove the wiper arms using the tool [1] (2).
Push back the seal (in the zone «A»).
Unclip the air intake grille in front of the windshield (3) (up).
Remove the air intake grille (3).
Nut tightening torque (1): 25 Nm.
Wiper mechanism
Remove fasteners (1).
Disconnect connector (2).
Remove the wiper mechanism (3).
Installation
Attention. Before tightening the wiper arms, operate the wiper, set the combination switch lever to the stop position, and position the wiper arms correctly.
Tighten fasteners (1) torque 8 Nm.
Install the parts in reverse order.