Removing
Partially disassemble the tailgate (see section «Body»).
Detach the cover (1) (in the zone «A»), unscrew the nut (2) and remove the cover.
Remove the rear wiper arm (3).
Tailgate with fixed glass.
Disconnect the connector in the area «b».
Drill Rivets (5) drill with a diameter of 8 mm.
Remove the wiper motor (6) and sealant (4).
Tailgate with sliding glass
Loosen the nuts (in the zone «With») and remove the bearing (7).
Disconnect the connector in the area «d».
Drill Rivets (8) drill with a diameter of 8 mm.
Remove the wiper motor (9).
Installation
Attention. Use a vacuum cleaner to clean the bottom of the door from particles of rivets.
Install the rear wiper arm (3) (on the heating line) (in the zone «e»).
Installation is made in an order, the return to removal.
Tighten:
- nut (2) torque 25 Nm;
- nuts (5) And (8) torque 8 Nm;
- other nuts torque 12 Nm (in the zone «With»).