System activation
Turn off the ignition and get out of the car.
Lock the doors with the remote control while locking or super locking the locks.
The system is activated, and the control lamp of button A will flash every second.
System shutdown
Unlock the doors with the remote control.
In this case, the alarm is deactivated and the button lamp A goes out.
Deactivating the cabin space control system
Switch off the ignition.
Within 10 seconds at the latest, press button A until the control lamp comes on and stays on.
Get out of the car.
Lock the doors with the remote control while locking or super locking the locks.
In this case, only the perimeter monitoring function remains active, while the signal lamp of button A flashes every second.
Switching on the cabin space control system
Unlock the doors with the remote control.
Lock the doors with the remote control.
Both functions become active and the signal lamp of button A goes out.
System actuation
When the alarm is triggered, a siren sounds and the direction indicators flash for about 30 seconds.
After that, the system again switches to standby mode, remaining active.
Attention. If the system is activated ten times in a row, it will not react on the 11th.
If the control lamp of button A flashes at an accelerated frequency, then the burglar alarm has been triggered. When the ignition is switched on, this flashing stops.
To prevent accidental operation of the system while washing the vehicle, it should be locked in the normal way by turning the key in the driver's door lock.
Do not turn on the security alarm if you are going to disconnect the battery - otherwise the siren will sound.
Health check
If, when the ignition is turned on, the control lamp of button A lights up for 10 seconds, then the siren is faulty or connected incorrectly.