Steering gear rubber gaiter — renewal (Peugeot 106)

1. On diesel models, to improve access, remove the inlet manifold as described in Chapter 4D.

2. Unscrew the securing bolts (while counterholding the nuts) and disconnect the inner ends of the track-rods from the steering gear (see illustration).



3. Unscrew the two securing bolts and remove the upper and lower sections of the track-rod bracket (see illustrations).



4. Release the securing clip from the pinion end of the gaiter, then slide the gaiter from the steering gear (see illustration).



5. Fit the new gaiter using a reversal of the removal procedure. Tighten all fixings to the specified torque and (where applicable) refit the inlet manifold as described in Chapter 4D.