Attention! The oil level depends on the temperature.
Examination
1. With the engine off, set the wheels to drive straight ahead.
2. Check the oil level in the tank.
3. Top up the amount of oil so that its level is between the two marks. The oil level must never be below the mark "mini".
Replacement
1. Put the car over the pit or on a lift. Disconnect battery.
2. Drain the oil from the hydraulic circuit by disconnecting the high pressure hose from the separating valve. Finish draining the oil from the circuit by turning the steering wheel several times in both directions until it stops.
3. Check that the high and low pressure connections are well secured.
4. Pour 0.3 dm3 oil into the pump reservoir.
5. With the engine off, slowly turn the steering wheel in both directions until it stops.
6. Top up the amount of oil in the tank to the required level.
7. Start the engine.
8. Remove air from the circuit by turning the front wheels several times in both directions until they stop and adding oil as the level in the reservoir decreases.