Table of contents: Adjusting the fuel level in the…🠇 Idle speed adjustment 🠇
Ignition distributor with booster module and ignition coil
1 – ignition distributor housing; 2 – ignition distributor; 3 – distributor rotor; 4 – casing; 5 – bearing; 6 – fastening ring; 7 – rotor; 8 – pulse generator; 9 – stator with protrusions; 10 – base; 11 – vacuum regulator; 12 – amplification module; 13 – ignition coil; 14 – reel stand; 15 – ignition distributor housing mounting bolt
Solex 32/34 Z2 carburetor sections
a – longitudinal section,
b – cross-section,
1 – idle fuel jet; 2 – main air jets; 3 – float; 4 – needle valve; 5 – diffuser; 6 – main fuel jets; 7 – transition system tube; 8 – enrichment device spring; 9 – accelerator pump nozzles; 10 – accelerator pump; 11 – enrichment device valve; 12 – enrichment device diaphragm; 13 – enrichment device valve spring; 15 – enrichment device air jet; 16 – enrichment device sprayer;
A – 1st chamber,
B – 2nd chamber
Carburetor components Solex 32/34 Z2
1 – carburetor cover; 2 – carburetor; 3 – carburetor gasket; 4 – emulsion tubes; 5 – fuel filter; 6 – needle valve; 7 – float; 8 – throttle opening adjustment bolt; 9 – vacuum device for opening the air damper after starting the engine; 10 – enrichment device; 11 – accelerator rod lever assembly
(Original publication on the website: www.PeugeotBook.ru)
Adjusting the fuel level in the float chamber
1. Remove the air filter with pipes.
2. Unscrew the fuel lines from the carburetor cover and close them with plugs.
3. Remove the carburetor cover.
4. Turn the carburetor cover together with the gasket until it is horizontal.
5. Check the float setting in this position using the appropriate control template (the template should be aligned with the floats).
6. If necessary, adjust the float setting by bending or unbending the float tongue (1 – tongue shoulder before adjustment).
Idle speed adjustment
Verification conditions:
- the engine must be warmed up to normal operating temperature;
- the starting device must be switched off;
- the air filter must be installed and have a clean filter element;
- the intake and exhaust systems must be sealed;
- all electrical consumers must be switched off (for example, an electric fan, headlights, etc.).
1. Check and, if necessary, adjust the idle speed using the throttle valve support screw.
2. Check the CO content in the exhaust gases and, if necessary, adjust the mixture quality screw (1) (the screw is recessed into the carburetor body and closed with a special plug).
3. Check the idle speed again and adjust if necessary.