Table of contents: Removal and refitting 🠇 Adjustment 🠇
Removal and refitting
1. Refer to Chapter 4A, Section 7, substituting "throttle body" for all references to the carburettor. Adjust the cable as described below.
Adjustment
2. Remove the spring clip from the accelerator outer cable then, ensuring that the throttle cam is fully against its stop, gently pull the cable out of its grommet until all free play is removed from the inner cable.
3. With the cable held in this position, ensure that the flat washer is pressed securely against the grommet, then fit the spring clip to the third outer cable groove visible in front of the rubber grommet and washer (see illustration). This will leave a fair amount of freeplay in the inner cable, which is necessary to ensure correct operation of the idle control stepper motor.
4.3. Adjust the accelerator cable as described in text
4. Have an assistant depress the accelerator pedal and check that the throttle cam opens fully and returns smoothly to its stop.
Article republished from the website [www.PEUGEOTBOOK.ru]