Remove the fuse box access trim.
Release the decorative element (2) from the retainers (in zones "c", "d", "e") and remove it.
Loosen the screw (3).
Detach the side trim of the control panel (4) (in areas "f", "g", "h") and remove it.
Loosen screws (5) and (6).
Lift the latch tab (in the "j" area) using a thin screwdriver.
Place your finger through the fuse box access hole to push the rear vent grille in the instrument panel (in the "k" area).
Disconnect the control panel ventilation grille.
The right part (in zone "l").
Left part (in zone "m").
Disconnect the control panel ventilation grille (7).
The upper part (in zones "n" and "p").
The side part (in the "q" zone).
Before installation, check the condition of the seal (8) (replace if necessary).
Insert the ventilation grille (7) into the control panel and press it down to secure it in place.
Install the remaining parts in reverse order.
Check the operation of electrical equipment.
