Table of contents: Static pressure test 🠇 Removal and installation 🠇
Fuel system with carburetor
1 – Intake manifold, 2 – Intake manifold gasket, 3 – Carburetor, 4 – Carburetor inlet pipe, 5 – Joint, 6 – Air duct, 7 – Air filter housing, 8 – Replaceable air filter element, 9 – Bracket, 10 – Connecting tube, 11 – Air duct, 12 – Warm air intake
Static pressure test
1. Disconnect the fuel supply line to the carburetor.
2. Install a tee with a pressure gauge on the pipeline to measure pressure.
3. Start the engine and measure the pressure at idle and at high speed (5000 rpm)this pressure should be about 0.03 MPa.
Removal and installation
1. Mark the fuel supply and outlet hoses from the pump, remove the hoses and plug them with plugs.
2. Unscrew the nuts securing the fuel pump to the end of the cylinder head and remove the pump with the heat-insulating spacer.
3. Installation in its original place is carried out in the reverse order of removal.
(Source of the article is posted at www.PEUGEOTBOOK.ru)