Table of contents: General information 🠇 Precautions 🠇
General information
Because of their engine-related functions, the components of the starting and charging systems are covered separately from the body electrical devices such as the lights, instruments, etc (which are covered in Chapter 12). On petrol models, refer to Part B of this Chapter for information on the ignition system. On diesel models, refer to Part C for information on the preheating system.
The electrical system is of the 12-volt negative earth type.
The battery is of the low-maintenance or "maintenance-free" (sealed for life) type and Is charged by the alternator, which is belt-driven from the crankshaft pulley.
The starter motor is of the pre-engaged type, incorporating an integral solenoid. On starting, the solenoid moves the drive pinion into engagement with the flywheel ring gear before the starter motor is energised. Once the engine has started, a one-way clutch prevents the motor armature being driven by the engine until the pinion disengages from the flywheel.
Precautions
Further details of the various systems are given in the relevant Sections of this Chapter. While some repair procedures are given, the usual course of action is to renew the component concerned. The owner whose interest extends beyond mere component renewal should obtain a copy of the "Automotive Electrical & Electronic Systems Manual", available from the publishers of this manual.
[Material copied from the resource Peugeotbook.ru]
It is necessary to take extra care when working on the electrical system, to avoid damage to semi-conductor devices (diodes and transistors) and to avoid the risk of personal injury. In addition to the precautions given in "Safety first!" at the beginning of this manual, observe the following when working on the system:
- Always remove rings, watches, etc before working on the electrical system. Even with the battery disconnected, capacitive discharge could occur if a component's live terminal is earthed through a metal object. This could cause a shock or nasty burn.
- Do not reverse the battery connections. Components such as the alternator, electronic control units, or any other components having semi-conductor circuitry could be irreparably damaged.
- If the engine is being started using jump leads and a slave battery, connect the batteries positive-to-positive and negative-to-negatlve (see "Jump starting"). This also applies when connecting a battery charger.
- Never disconnect the battery terminals, the alternator, any electrical wiring or any test instruments, when the engine is running.
- Do not allow the engine to turn the alternator when the alternator is not connected.
- Never "test" for alternator output by "flashing" the output lead to earth.
- Never use an ohmmeter of the type incorporating a hand-cranked generator for circuit or continuity testing.
- Always ensure that the battery negative lead is disconnected when working on the electrical system.
- Before using electric-arc welding equipment on the car, disconnect the battery, alternator and components such as the fuel injectionfignition electronic control unit, to protect them from the risk of damage.
- Several systems fitted to the vehicle require battery power to be available at all times, either to ensure their continued operation (such as the clock) or to maintain control unit memories or security codes which would be wiped if the battery were to be disconnected. To ensure that there are no unforeseen consequences of this action, Refer to "Disconnecting the battery" for further information.