Table of contents: Removal and refitting 🠇 Adjustment 🠇
Removal and refitting
1. Refer to Chapter 4A, Section 7, substituting "injection pump" for all references to a carburettor. Adjust the cable as described below.
Adjustment
2. Remove the spring clip from the accelerator outer cable then, ensuring that the pump accelerator lever is fully against the anti-stall screw, gently pull the cable out of Its grommet until all free play is removed from the inner cable.
3. With the cable held in this position, ensure that the flat washer is pressed securely against the grommet, then fit the spring clip to the first outer cable groove visible in front of the rubber grommet and washer (see illustration).
3.3. Adjusting the accelerator cable
4. Have an assistant depress the accelerator pedal and check that the accelerator lever opens fully, so that it contacts the maximum speed screw and returns smoothly to its stop against the anti-stall screw.