Remove the following parts:
- air deflector (4);
- air resonator (5);
- bolt (2);
- air intake connector (3).
Disconnect the camshaft position sensor electrical connector (in the zone «A»).
Release the clamps in the area «b».
Note. When removing, use a rag to protect the equipment from oil escaping from the hole.
Turn away bolts (6) and remove the sensor (1).
Attention. When reusing the sensor, replace the gasket.
Note. Clean the sensor installation area and check for impact marks and scratches.
Install the parts in reverse order.
Tightening torque for sensor mounting bolts: 8 Nm.