Raise the vehicle and secure it so that the wheels are off the floor.
Remove the following parts:
- protection under the engine;
- front right wheel;
- front liner;
- accessory drive belt.
Install the engine flywheel locking pin [1] in the hole in the crankshaft bearing cap.
Rotate the engine in the normal direction of crankshaft rotation until the pin [1] is seated in the hole.
Remove the bolt (3) and remove the pulley (2).
Unplug the electrical connector in the area «A».
Attention. The magnetic track must not show any signs of damage, and magnetized objects should not be brought close to it, otherwise replace the crankshaft pulley.
Turn away bolts (3) And (4) and remove the crankshaft sensor (5).
Note. In order to freely remove the sensor, move the protective cover of the gas distribution mechanism.
Install the parts in reverse order.